New Old Stock Cheetah Brand Center Gear Box for Twin Spindle Rotary Cutters.

Gearbox ratio - 1:1.21

Input shaft - 1-3/8", 6 Spline

Output shafts - 1-3/8", 6 Spline Gear Box has 4 mounting holes on each side.

The gearbox side bolt holes are 3-1/4" inch apart measuring left to right (from center of hole to center of hole).  The bolt holes are 5" inch apart measuring lower to upper bolt hole (measuring center of bolt hole to center of bolt hole).

The two lower mounting holes are 5" inches apart. The two lower bolt holes are shown in the last photo.

Mounting bolt holes are 9/16" inch diameter.

Please measure your current rotary cutter gearbox to make sure the above measurements match before ordering.

This gearbox is commonly used in many center deck applications on 8' & 10' rotary cutters.

Cheetah Center Gear Box part number H-61T,  H61T.

SHIPPED DRY,  please remove plastic filler plug and fill with lubricating oil. Then replace filler plug with an appropriate vent plug prior to usage.

Rotary cutters are also referred to rotary mowers, Bush Hogs, or brush hogs in different areas of the country.

Came from a shortline farm equipment manufacturer liquidation.